OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P24B9

EVAP System Leak Detection Pump Pressure Sensor Circuit Range/Performance

P24B9 means the leak check module's pressure sensor delivers a signal that is electrically valid but not believable. GM's 2018 Volt table (ELCP) compares the absolute sensor reading with barometric pressure from the MAP sensor while pump and valve rest; a gap above 3,000 Pa at the engine-off wake-ups (roughly 4 to 11 h after shutdown) or above 15,000 to 20,000 Pa while driving counts as a fail, 50 of 63 samples, Type B. Mitsubishi's 2023 Outlander PHEV instead counts signal noise during the key-off test and fails after more than 20 fluctuations. FCA fixed P24B9 with PCM software on the 2017 Pacifica and the 2025 Grand Cherokee 4xe (18-079-25). P24BA and P24BB are the hard voltage limits.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / B9

Possible causes

  • Pressure sensor in the leak check module drifted or noisy high
  • Engine control software needing an update (FCA bulletins) medium
  • Moisture or dirt in the module's pressure port medium
  • Chafed wiring or loose pin causing signal disturbance low

Symptoms

  • Malfunction indicator lamp on
  • EVAP leak test aborted, readiness not set
  • Usually no noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P24B9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication