OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P24B8

EVAP System Leak Detection Pump Pressure Sensor Circuit

P24B8 is the general circuit fault of the pressure sensor that sits inside an evaporative leak check module together with the pump and the switching valve. The sensor gets a 5 V reference from the engine computer and reports canister-side pressure during the engine-off leak test. No manufacturer documents P24B8 publicly; GM, Mitsubishi and Subaru use the more specific P24B9 to P24BB for this sensor. CARB requires such EVAP input components to be checked for circuit faults and implausible values. With this fault present, the leak test cannot be trusted and will not complete, so the EVAP readiness flag stays open. Typical findings are a broken reference or ground wire, a corroded module plug or a failed module.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / B8

Possible causes

  • Open or shorted 5 V reference, ground or signal wire to the leak check module high
  • Corroded or loose connector at the leak check module near the canister medium
  • Pressure sensor inside the leak check module failed medium
  • Engine control module does not supply the sensor reference low

Symptoms

  • Malfunction indicator lamp on
  • EVAP readiness monitor does not complete

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P24B8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication