P24B3
Particulate Matter Sensor Heater Control Circuit/Open
P24B3 means the heater inside the particulate matter sensor cannot draw the current it should while it is switched on, typically because the heater line is open. The heater is needed to burn soot off the electrodes. Ford's 2023 diesel summary checks continuously during sensor regeneration and sets the code when heater current stays below 0.2 A for about 2 s. GM's 18OBDG04 table watches for less than 0.5 A or more than 15 A while heating is requested (Type B); for the 2014 Touareg, VW judges the coil resistance. On 2019 L5P heavy-duty pickups, GM's PIP5607 warns that P24B3 or P24B5 could appear without any hardware fault. Ford's remedy in 18-2225 is a new sensor. P24B5 and P24B6 are the shorts.
Possible causes
- Heater element burnt out inside the sensor high
- Open heater wire or connector medium
- False detection in the control software low
Symptoms
- Malfunction indicator lamp on
- Particulate filter monitor does not complete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24B3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG04 Engine Diagnostics.pdf
- static.nhtsa.gov/odi/tsbs/2014/MC-10074008-2280.pdf
- static.nhtsa.gov/odi/tsbs/2018/MC-10149066-9999.pdf
- static.nhtsa.gov/odi/tsbs/2018/MC-10153928-9999.pdf