P24AD
EGR Cooler Coolant Pump Feedback Circuit High
P24AD is the high-side counterpart of P24AC: the return signal from the EGR cooler coolant pump stays above its valid band. Since such feedback lines are usually pulled up inside the controller, a broken wire or a disconnected pump often shows as a constantly high level, as can a short to a voltage feed. The pump itself may still run normally, but the controller can no longer prove it. As with the low-side code, no maker discloses the band, so the general CARB input checks are the reference. A practical first step is to compare the feedback signal with the command while the pump is triggered from a scan tool, then check the line for continuity and for voltage from other circuits.
Possible causes
- Feedback wire broken or pump unplugged, line pulled high high
- Feedback wire shorted to a voltage feed medium
- Pump electronics no longer pulling the signal down low
Symptoms
- Malfunction indicator lamp on
- Often no noticeable effect while driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24AD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.