P24A9
EGR Cooler Coolant Pump Control Circuit Low
P24A9 reports that the voltage on the control line of the electric EGR cooler coolant pump is lower than the driver stage expects in its current switching state, which usually points to a harness or pump-internal short to ground, or to a chafed wire touching the engine block. Whether low means switched on permanently or not at all depends on how the manufacturer drives the pump (low-side or high-side switching, or a PWM signal). Published limits are not available from any maker, so CARB's rules for monitoring actuator circuits and supplier notes on EGR coolers stand in. Inspect the harness near hot exhaust parts for melted insulation. P24AA is the short-to-supply counterpart, P24A7 the open line.
Possible causes
- Control wire chafed through and shorted to ground high
- Insulation melted near exhaust or EGR parts medium
- Internal short in the pump electronics medium
Symptoms
- Malfunction indicator lamp on
- Pump may run continuously or not at all
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P24A9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.