P24A2
Particulate Filter Regeneration Incomplete (Bank 1)
P24A2 judges the outcome of a regeneration on the bank 1 filter: the event ended, but the estimated soot left in the filter is still above the allowed level. Ford's 2023 diesel summary runs this once per regeneration for up to 40 minutes and compares the soot estimate at the end with a threshold. Deutz uses P24A2-00 for a regeneration stopped because the temperature got too high, and Hino bulletin SB-22-007 lists it together with P24A1 for a fuel filter issue on 2020 trucks. CARB demands detection of a filter that does not regenerate properly. Too low or too high exhaust temperatures, aborted regenerations and pressure sensor errors are common reasons. P243E is the bank 2 version; P24A4 follows if soot keeps rising.
Possible causes
- Regenerations interrupted by short trips or engine shut-off high
- Exhaust temperature not reaching target (doser, oxidation catalyst, sensors) medium
- Differential pressure sensor or its hoses giving a wrong soot estimate medium
- Regeneration stopped by over-temperature protection low
Symptoms
- Malfunction indicator lamp or filter warning on
- More frequent regenerations, higher fuel consumption
- Reduced power if soot keeps building
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P24A2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.