P249B
EGR Cooler Bypass Position Sensor Circuit Intermittent/Erratic (Bank 2)
P249B flags short dropouts or implausible jumps in the bank 2 bypass position signal that are too brief to count as a steady low or high fault. Public manufacturer documentation for it does not exist, and even the well documented bank 1 sensor on GM's Duramax only has low, high and learning checks, without an erratic test of its own. If a controller does use P249B, the cause is rarely the sensor itself: heat cycling near the turbocharger, vibration and road splash attack terminals and harness on the second bank. A freeze-frame or a recorded drive helps to see under which load and temperature the signal breaks up. Fixing a terminal is usually enough; a new valve only follows if the fault lies inside. The bank 1 code is P2496.
Possible causes
- Fretting or loose terminal in the bank 2 sensor plug high
- Harness brittle from heat near the turbocharger medium
- Intermittent fault inside the sensor low
Symptoms
- Check engine light appears now and then
- Bank 2 position value flickers in the live data
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P249B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.