P249A
EGR Cooler Bypass Position Sensor Circuit High (Bank 2)
P249A is logged when the bank 2 bypass position signal sits near the top of the reference voltage. Like its siblings on this bank, it is not described by any manufacturer in public documents. The bank 1 analogue P2495 is set by GM's Duramax logic once the raw value exceeds 99 % of 5 V in most of a 250-sample window, rated Type B with the lamp after two trips. A reading stuck at the top usually means the sensor has lost its ground, so the signal floats up to the supply, or that the signal wire has contact with a voltage source. A water-damaged connector can produce the same picture. Because sensor and bypass valve are often one part, a new valve is only justified after wiring and ground check out. Low on bank 2 is P2499.
Possible causes
- Lost ground at the bank 2 position sensor high
- Signal wire in contact with a supply line medium
- Water ingress in the sensor connector low
Symptoms
- Check engine light after two trips
- Bank 2 bypass position shows full scale
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P249A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.