P2496
EGR Cooler Bypass Position Sensor Circuit Intermittent/Erratic (Bank 1)
P2496 targets a bank 1 bypass position signal that jumps, drops out briefly or changes faster than the flap can physically move, without staying outside the electrical limits long enough for P2494 or P2495. No manufacturer documents P2496 publicly; GM's Duramax tables, which do cover the same analog sensor, only list the low, high and learning checks. The fault pattern is typical of loose terminals, a wire that breaks inside its insulation when the engine rocks, moisture creeping into the connector or a worn contact track in the sensor. Because the signal looks fine most of the time, the code may come and go; wiggling the harness while watching live data is the most useful test. CARB treats such sensors as comprehensive components. Bank 2 uses P249B.
Possible causes
- Loose or spread terminal in the sensor connector high
- Wire breaking inside the insulation from engine movement medium
- Worn contact track inside the sensor low
Symptoms
- Check engine light that comes and goes
- Bypass position value jumps in the live data
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2496
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.