OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2492

EGR Cooler Bypass Position Sensor Circuit (Bank 1)

The position sensor tells the controller where the bank 1 cooler bypass flap actually is; position-controlled flaps cannot be regulated without it. P2492 is the general circuit code for that sensor, used when the fault cannot be classed as a short to ground or to the supply. No manufacturer documents P2492 publicly. GM's Duramax tables from 2017 and 2018 monitor the same analog sensor, but split the electrical faults into P2494 (below 1 % of the 5 V reference) and P2495 (above 99 %), both Type B; a separate learning check at key-off is P24C4. Without a valid feedback signal the controller usually stops closed-loop flap control, which can then also set P245B. Damaged wiring, a loose connector or a lost 5 V reference are the main suspects.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 92

Possible causes

  • Damaged sensor wiring near hot exhaust parts high
  • Loose or corroded connector at the bypass valve medium
  • 5 V sensor supply missing or shared circuit shorted low

Symptoms

  • Check engine light on
  • Bypass flap no longer position-controlled

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2492

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication