OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2490

EGR Cooler Bypass Control Circuit Low (Bank 2)

P2490 means the drive line of the bank 2 cooler bypass actuator sits too close to ground potential, typically a grounded wire between controller and actuator. It mirrors P245C on bank 1. No manufacturer documents P2490 publicly. GM's 2017 diesel tables give an idea of the bank 1 test: the vacuum-switched bypass is failed when the resistance to ground falls below 0.5 Ohm in 24 of 30 samples. Depending on the wiring, a grounded control line can keep the actuator permanently energised or permanently released, so bank 2 either always bypasses or always cools. Look for chafed insulation near the exhaust manifolds and turbocharger, harness clips lost after repairs and water in the connector. An open is P248E, a short toward the supply P2491.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 90

Possible causes

  • Drive wire rubbed through and touching engine ground high
  • Water or corrosion in the bank 2 actuator connector medium
  • Internal short in the actuator low

Symptoms

  • Check engine light on
  • Bypass on bank 2 stuck in one mode, possibly followed by cooler efficiency codes

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2490

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication