P2484
Exhaust Gas Temperature Sensor Circuit Intermittent/Erratic (Bank 1 Sensor 5)
P2484 catches a fifth bank 1 exhaust probe whose signal jumps faster than any real exhaust temperature can change. GM's diesel ECMs compare consecutive samples taken every 100 ms. In the 2018 table the resistance difference between two samples is evaluated, and 15 failed samples out of 30 set a Type B code. The 2025 table uses a temperature step above 100 °C, needs 12 of 25 samples and runs only while the unfiltered value lies between 140 and 1070 °C and no electrical fault of the probe is present. GM lists internal probe faults, worn harnesses and connector problems as failure modes. Unlike P2481 and P2482, the signal stays within its limits, so wiggle tests on the harness while watching live data are the quickest way in.
Possible causes
- Intermittent contact in the probe connector high
- Harness insulation worn by heat or rubbing medium
- Probe element cracking internally medium
Symptoms
- Warning lamp, sometimes going out again
- Erratic jumps of probe 5 in live data
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2484
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.