OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2483

Exhaust Gas Temperature Sensor Circuit Range/Performance (Bank 1 Sensor 5)

P2483 is the plausibility test for the fifth bank 1 exhaust probe: the circuit is electrically fine, but the reading does not behave like a real exhaust temperature. GM's 2025 diesel tables describe the check in detail. After the engine has been off for more than 10,800 s (three hours), the value frozen at key-on serves as reference; if the probe then fails to rise by the amount a calibrated map expects while the engine runs, the ECM concludes it is stuck or no longer in the gas stream. It is a Type B fault and waits until the electrical codes P2481, P2482 and P2484 are clear. Hino also issued workshop-manual corrections for P2483 on its 2018–2019 J08E trucks. A probe pulled out of its boss after work on the exhaust is a classic cause.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 83

Possible causes

  • Probe not fully seated in its boss after exhaust work high
  • Probe output stuck or responding too slowly medium
  • Heavily sooted probe tip insulating the element low

Symptoms

  • Warning lamp after two trips
  • Probe 5 barely changes while the other probes heat up

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2483

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication