P247E
Exhaust Gas Temperature Out of Range (Bank 2 Sensor 3)
P247E does not question the wiring but the value itself: the third exhaust probe on cylinder bank 2 reports a temperature the engine control unit will not accept, in practice mostly an implausibly hot one. The code only makes sense on a V engine whose two banks keep separate exhaust paths up to the third measuring point. No maker publishes P247E; the bank 1 twin P247A is used by Ford's 2015 diesels with a high-side limit of about 1150 °C and by Volkswagen's 2014 Touareg V6 TDI, which flags a target-to-actual gap above 200 K. CARB requires such inputs to be checked for range and plausibility. Look at the bank 2 regeneration and fuelling first; a probe that reads hot at a cold start is simply faulty.
Possible causes
- Uncontrolled soot burn or too much post-injection fuel on bank 2 medium
- Probe drifted and reports values too high medium
- Leaking injector or turbo oil leak on bank 2 low
Symptoms
- Warning lamp on, regeneration may be aborted
- Reduced power to protect the aftertreatment
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P247E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.