P247C
Exhaust Gas Temperature Out of Range (Bank 2 Sensor 1)
P247C is the bank 2 counterpart of P2478: the first exhaust probe on the second cylinder bank reports a temperature outside its permitted window, typically next to the turbine outlet or catalyst inlet of that bank. It needs a V engine with separate exhaust paths and its own probe per bank. No maker documents P247C in public material; Ford's 2015 diesels with their single exhaust stream use only the bank 1 numbers, with a high-side limit of about 1150 °C, and Volkswagen's 2014 2.0L TDI checks the target-to-actual gap. Comparing both banks helps: if only bank 2 runs hot, look at that bank's injectors, turbo and air supply before replacing the probe.
Possible causes
- Bank 2 running hot from extra fuel or a faulty injector high
- Bank 2 probe 1 reading too high medium
- Air shortage on bank 2 from a boost leak or turbo fault low
Symptoms
- MIL on
- Reduced power to protect the exhaust
- Bank 2 probe reads clearly above bank 1
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P247C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.