P2476
Exhaust Gas Temperature Sensor Circuit High (Bank 2 Sensor 4)
P2476 covers the opposite end of the scale from P2475: the signal of bank 2 probe 4 sits above its usable ceiling. Because the probe forms a voltage divider with a pull-up resistor in the control unit, an interrupted wire, a disconnected plug or a short to a supply voltage all drive the input high. For the bank 1 equivalent P2471 Ford uses more than 4.90 V in its 2015 diesel summary and more than 2.66 V in the 2023 edition, both as continuous checks. P2476 is not listed by any maker in public documents; only engines with two banks and four probes per bank could set it. Expect a lit MIL and a substitute temperature, which can stop regeneration.
Possible causes
- Open signal or ground wire, often heat-damaged high
- Connector loose or not locked after service work medium
- Signal wire shorted to a supply voltage low
Symptoms
- MIL on
- Probe reads maximum or an implausibly hot value
- Regeneration blocked
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2476
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.