P2475
Exhaust Gas Temperature Sensor Circuit Low (Bank 2 Sensor 4)
P2475 is stored when the voltage from bank 2 probe 4 falls below the lowest value the probe can produce in normal use. With the resistive PTC probes common on diesels this points to a short between signal and ground, or to a sensor shorted internally. Published thresholds exist only for the bank 1 twin P2470: Ford's diesels treat less than 0.10 V as a fault after about 2 s with the key on, and GM's diesel tables test the probe input for a grounded condition as a Type B fault. No maker lists P2475 itself. The value of this probe is then replaced by a default, so the controller may restrict regeneration or reductant dosing until the repair.
Possible causes
- Signal wire rubbed through against the exhaust or body high
- Probe shorted internally medium
- Water in the connector bridging the pins low
Symptoms
- MIL on
- Bank 2 probe 4 shows an implausibly cold or fixed value
- Regeneration or DEF dosing restricted
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2475
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.