P246E
Exhaust Gas Temperature Sensor Circuit (Bank 1 Sensor 4)
P246E is the general code for the fourth exhaust temperature probe on bank 1, usually the last one in the aftertreatment line. Ford's diesels give it a model check rather than an electrical one: after a cold start the measured EGT14 value may differ from the modelled temperature by no more than 80 °C, the comparison lasting 200 to 400 s and the deviation having to persist for 20 s. Dedicated low and high signal faults of the same probe go to P2470 and P2471, and sensor-to-sensor plausibility to P246F. Volvo Trucks lists P246E-15 among the EGT faults on VNL tractors whose fix is replacing the affected exhaust temperature sensor (RD24-034). CARB requires continuity and rationality checks on emission-relevant inputs. A bad value often pauses regeneration or DEF dosing.
Possible causes
- Probe aged or failed, reading far from the model high
- Probe loose or not reaching into the gas stream medium
- Exhaust leak near the probe cooling the reading low
Symptoms
- MIL on
- Value of the last exhaust probe deviates from expectation
- Regeneration or DEF dosing suspended
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P246E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.