OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P246C

Particulate Filter Restriction - Forced Limited Power (Bank 1)

P246C is the final stage of the bank 1 filter loading monitor: the filter is judged so clogged that the controller reduces engine output to protect engine and filter. Ford uses it on diesels with an immediate MIL plus wrench light. In the 2015 summary a normalised restriction of twice the normal soot value above 625 rpm for 300 s sets it and EGR is switched off; the 2023 summary uses an estimated soot mass of 200 % of the normal regeneration trigger. Ford's 2024 petrol summary applies the code to the gasoline filter as well, with normalised back pressure above 1.0 for 5 s once the filter is above 250 °C at 400–850 m³/h. Ford bulletins for the 3.2 L Transit (18-2064) and 6.7 L Super Duty (21-2052) pair it with P2463 and fix it by forced regeneration or new PCM software. Bank 2 is P243B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 6C

Possible causes

  • Soot overload after repeatedly missed or aborted regenerations high
  • Mostly stationary or low-speed operation without full regenerations medium
  • Filter at the end of its life with high ash content medium
  • PCM calibration overestimating soot load (Ford bulletins) low

Symptoms

  • MIL and service or wrench light on
  • Marked loss of power (limp mode)
  • Drive-to-clean or filter full message

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P246C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication