P246B
Vehicle Conditions Incorrect for Particulate Filter Regeneration
P246B says the controller wanted to clean the particulate filter but the vehicle did not offer the conditions its strategy needs, for example enough exhaust heat, a long enough run or a functioning air path. It describes a failed or blocked regeneration request rather than a defective part on its own, so the real cause is usually stored beside it. Land Rover documents exactly that on Range Rover and Range Rover Sport 2016–2018 and Discovery 2017–2018 with the 3.0 L TDV6: P246B-00 and P2463-00 can accompany P0234-77 when the intake air shutoff throttle has failed, and bulletins LTB01204NAS1 to NAS3 call for a new throttle followed by a dynamic regeneration. Short trips and long idling make it worse, and if soot keeps rising P2463 or a power limit follows. MIL behaviour differs by maker.
Possible causes
- Another stored fault (e.g. intake throttle, sensors) blocking regeneration high
- Failed intake air shutoff throttle (Land Rover TDV6) medium
- Short trips or long idling without enough exhaust heat medium
Symptoms
- Regeneration does not start or is aborted repeatedly
- Filter warning or rising soot load
- MIL on together with the root-cause code on some vehicles
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P246B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.