OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2460

Particulate Filter Pressure Sensor B Circuit Low

P2460 means the analog output of pressure sensor B has fallen below the lowest voltage a working sensor can deliver. On Ford's 2013 6.7 L diesel, sensor B is the differential pressure sensor across the filter; its output runs from about 0.45 V at zero to roughly 4.8 V near 38 kPa, and anything under 0.10 V for 2 s with the key on, battery between 9 and 16.25 V, sets the code. Ford's 2024 gasoline filter strategy uses a higher floor of 0.3 V held for 5 s. A missing 5 V reference, a grounded signal wire or an open in the signal line pulled down inside the controller all look the same here, so a check of reference, ground and signal at the connector comes first. The soot estimate loses one input and regeneration planning gets less accurate. The high case is P2461, erratic signals P2462.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 60

Possible causes

  • 5 V reference to sensor B missing or shorted high
  • Signal wire chafed and shorted to ground medium
  • Sensor B internally failed with output stuck low medium

Symptoms

  • Malfunction indicator lamp on
  • Regeneration based on a model only, possibly more frequent

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2460

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication