P245F
Particulate Filter Pressure Sensor B Circuit Range/Performance
With P245F the controller decides that the sensor B value is electrically fine but makes no physical sense. Ford's 2024 gasoline strategy runs three such tests on the B sensor of the gasoline particulate filter: an offset check with the engine stopped that fails once the average reaches 16 to 32 hPa; a rationality check that fails when the reading stays at or above the pressure expected for the current exhaust flow for a total of 20 s; and a derivative check that compares how fast pressure follows a change in flow over 2 s. Jeep released PCM software for 2018 Wranglers with a gasoline filter in Asia-Pacific and EMEA markets that set P245F together with P2453. Deutz assigns P245F to the pressure after the filter leaving its physical limits. Hoses, condensate and sensor drift are the usual suspects. Circuit codes are P245E, P2460 and P2461.
Possible causes
- Sensor B hose cracked, disconnected or blocked high
- Condensate in the pressure line falsifying the reading medium
- Sensor B drifted out of calibration medium
- Control software needing an update (some Jeep models) low
Symptoms
- Malfunction indicator lamp on
- Filter regeneration triggered too early, too late or blocked
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P245F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.