OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P245C

EGR Cooler Bypass Control Circuit Low (Bank 1)

P245C reports that the control line of the bank 1 bypass actuator is pulled toward ground. GM documents this in its diesel tables: in 2014 the driver stage detects low voltage while it is switched off and treats it as a ground short, and in the 2017 tables the vacuum-switched bypass fails when the resistance to ground drops below 0.5 Ohm in 24 of 30 samples, rated Type B. With the line shorted the actuator may sit permanently in one position, so the cooler is either always bypassed or always used, which the efficiency check P2457 can then also notice. Typical findings are insulation rubbed through against the engine or exhaust, a pinched harness after repairs or a shorted solenoid winding. The open case is P245A, a short to supply P245D, and bank 2 has P2490.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 5C

Possible causes

  • Control wire chafed through and touching ground high
  • Shorted actuator or solenoid winding medium
  • Water or corrosion bridging connector pins low

Symptoms

  • Malfunction indicator lamp on
  • Bypass stuck in one position, possibly with EGR cooler efficiency code

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P245C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication