OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P245B

EGR Cooler Bypass Control Circuit Range/Performance (Bank 1)

P245B is set when the bank 1 bypass is electrically intact but does not reach or hold the commanded position, or when switching it has no visible thermal effect. GM's 2017 Duramax with a position-controlled DC-motor flap compares setpoint and feedback; a tracking error above 16 % in 1280 of 1600 samples, with a steady setpoint, coolant over 70 °C and outside air above minus 23 °C, sets a Type B fault, and P24A5 follows if the flap is then found stuck. Ford's 2023 diesels, the 6.7 L and the 3.0 L, run an intrusive test once per trip: the flap is moved, and if the gas temperature after the cooler changes by less than 3 °C per second, P245B is logged. Carbon on the flap shaft, a worn linkage, a weak vacuum supply or a position sensor fault are typical causes. Pure circuit faults are P245A, P245C and P245D.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 5B

Possible causes

  • Bypass flap or shaft sticking from carbon deposits high
  • Bypass position feedback inaccurate medium
  • Weak vacuum supply or leaking hose on vacuum-operated bypass medium
  • Slow EGR temperature sensor after the cooler low

Symptoms

  • Malfunction indicator lamp on
  • Longer warm-up or higher NOx when the bypass stays in one position

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P245B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication