OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P244E

Exhaust Temperature Too Low For Particulate Filter Regeneration (Bank 2)

P244E only exists on engines that have a separate particulate filter for the second cylinder bank, which is rare. No manufacturer documents this code publicly; it mirrors P244C, so the logic described for bank 1 applies here. GM, for example, counts regenerations on its 2017 diesels that end early because the heat-up never reached a stable phase, and gives that bank 1 fault a Type A rating. CARB requires diesel systems to detect a regeneration that fails to complete. On a two-filter layout the second bank lacks heat when its oxidation catalyst no longer converts the fuel, its exhaust temperature sensor reads low or the gas cools through a leak. Comparing both banks during a forced regeneration with a scan tool is the most direct check. Overheating of bank 2 is P244F.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 4E

Possible causes

  • Bank 2 oxidation catalyst no longer converting post-injected fuel high
  • Bank 2 exhaust temperature sensor reading low medium
  • Driving pattern too short for a complete regeneration medium
  • Exhaust leak on bank 2 ahead of the catalyst low

Symptoms

  • Malfunction indicator lamp on
  • Filter warning, regeneration does not complete

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P244E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication