OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P244C

Exhaust Temperature Too Low For Particulate Filter Regeneration (Bank 1)

During an active regeneration the engine raises exhaust temperature with late injections so the soot in the particulate filter can burn. P244C is stored when bank 1 does not get hot enough or does not stay hot long enough. GM's diesel tables of 2017 and 2018 count interrupted regenerations: the burn ran past its maximum time, the post injections were not released in time or the steady heating phase was never reached; a successful burn clears the counter, and the code is Type A after one trip. VW's 2014 TDI cars flag it when closed-loop temperature control upstream of the turbine is not active within 45 s, or ahead of the filter within 60 s. Deutz lists it as a failed regeneration. The bank 2 twin is P244E; P244D covers too much heat. Soot keeps building, so P2463 or P2459 may follow.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 4C

Possible causes

  • Oxidation catalyst aged or face-plugged, so the post-injected fuel does not light off high
  • Regenerations repeatedly cut short by short trips, idling or engine shut-off high
  • Exhaust temperature sensor ahead of catalyst or filter reading too low medium
  • Exhaust leak ahead of the catalyst cooling the gas low

Symptoms

  • Malfunction indicator lamp and particulate filter warning on
  • Regenerations noticeably frequent or never finishing
  • Reduced power once the filter is heavily loaded

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P244C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication