OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P243F

Particulate Filter Restriction - Soot Accumulation Too High (Bank 2)

P243F means the soot load estimated for the bank 2 particulate filter has climbed past the level that a normal regeneration can still handle safely. Burning off too much soot at once can overheat and crack the substrate, so many engines then block automatic regeneration and call for a service regeneration or a new filter. No manufacturer documents P243F publicly. For the bank 1 analogue P2463, GM's 2018 diesels estimate soot from the differential pressure and confirm the fault after 120 failures in 150 samples; the same GM table, oddly, labels P24A4, the J2012 bank 1 twin of P243F, as ash accumulation. Typical causes are long stretches of short trips or idling, regenerations that keep aborting and engine faults that raise soot output on that bank. Power reduction (P243B) may follow.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 3F

Possible causes

  • Repeatedly aborted regenerations, short trips or long idling high
  • Engine fault raising soot output on bank 2 (injector, EGR, boost) medium
  • Pressure sensor or hose overstating the soot load low

Symptoms

  • MIL and filter warning on
  • Automatic regeneration blocked, service regeneration needed
  • Reduced power possible

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P243F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication