P243E
Particulate Filter Regeneration Incomplete (Bank 2)
P243E is set when the second filter strand has finished regenerating but the soot was not burned off as planned. CARB requires a malfunction to be flagged whenever the filter does not regenerate properly under the manufacturer's intended conditions. Public manufacturer material covers only bank 1 here: for P24A2, Ford's 2023 diesels evaluate each regeneration, allow up to 40 minutes and store a fault if the soot estimate at the end is still above a threshold. Regenerations cut short by brief trips or switching off are the usual reason, followed by too little heat on that bank, a faulty temperature or pressure sensor or a fuel dosing problem. Ignored, the filter keeps loading until P243F or a power limit follows.
Possible causes
- Regenerations interrupted by short trips or engine shut-off high
- Too little heat on bank 2 (catalyst, post-injection or dosing fault) medium
- Faulty temperature or differential pressure signal medium
Symptoms
- MIL on, filter warning
- Regeneration restarts soon after the last one
- Rising soot load in live data
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P243E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.