P243C
Particulate Filter Regeneration Frequency (Bank 2)
P243C is stored when the bank 2 particulate filter needs regeneration more often than its calibration allows. CARB requires diesel OBD to recognise regeneration so frequent that emissions would rise above the limit. No manufacturer documents this bank 2 code publicly, so the bank 1 code P2459 serves as the reference: Ford's 2023 diesels flag it once completed regenerations occur, on average, less than roughly 40 km apart. Excess soot from the engine side of that bank, for example a leaking injector, an EGR or boost fault, or a pressure reading that overstates the load, makes the filter look full too early. Every extra regeneration burns fuel and can thin the engine oil. If the other bank regenerates at normal intervals, compare what differs on this side.
Possible causes
- Too much soot from bank 2 cylinders (injector, EGR or boost fault) high
- Pressure sensor or hose overstating the bank 2 soot load medium
- Filter partly filled with ash, leaving little soot capacity medium
Symptoms
- Regeneration running unusually often
- Higher fuel consumption, rising oil level
- MIL on
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P243C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.