P243A
Particulate Filter Restriction - Ash Accumulation (Bank 2)
P243A is the bank 2 counterpart of P242F: the ash load in the second particulate filter has grown so large that the filter chokes the exhaust and must be cleaned or replaced. A bank 2 filter only exists where each cylinder bank of a V engine feeds its own filter strand. No manufacturer documents this exact code publicly. Bank 1 monitoring shows how such a check works: GM's 2018 diesels judge ash by a filtered flow resistance derived from differential pressure and exhaust flow (Type A), and Deutz raises a warning once a modelled ash load limit is passed. Since ash does not burn, extra regenerations will not help and only waste fuel. If only one strand shows high back pressure or regenerates more often, the problem is confined to that side.
Possible causes
- Bank 2 filter full of ash after long service high
- Oil burning on bank 2 (valve stem seals, turbo seal) adding ash medium
- Bank 2 pressure sensor or hose reporting too much restriction low
Symptoms
- MIL or filter service message
- Higher fuel consumption from frequent regenerations
- Reduced power at high load
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P243A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.