OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P242F

Particulate Filter Restriction - Ash Accumulation (Bank 1)

P242F reports that so much incombustible ash has collected in the bank 1 particulate filter that it restricts flow and no regeneration can clear it. Ash comes mainly from oil additives, builds up over the service life and leaves the filter only through cleaning or replacement. Deutz stores P242F-00 as a high ash load warning on its EMR L1 controller. GM's 2018 diesel tables watch for the same condition but file it under P24A4, which GM labels ash accumulation: a filtered flow resistance from differential pressure and exhaust flow, 5 failures in 10 samples, Type A. On 2015 Ram 2500/3500 with the 6.7 L Cummins, Stellantis issued PCM software (18-037-16) because P242F could set with no defect present, so check the calibration first. Soot overload belongs to P2463; the second filter has P243A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 2F

Possible causes

  • Filter has reached its ash capacity after high mileage or operating hours high
  • High oil consumption or unsuitable oil (high ash content) speeding up ash build-up medium
  • Calibration setting the code without a defect (Ram 6.7 L 2015, bulletin 18-037-16) medium
  • Differential pressure sensor or hoses reporting too much restriction low

Symptoms

  • MIL or DPF service message
  • Regenerations becoming more frequent
  • Loss of power at high load due to back pressure

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P242F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication