P242E
Exhaust Gas Temperature Sensor Circuit Intermittent/Erratic (Bank 1 Sensor 3)
P242E is set when exhaust temperature sensor 3 on bank 1 jumps between two samples faster than real exhaust gas can change, even though each single value is inside the valid range. GM documents this as a quick-change monitor that runs every 100 ms. The 2020 diesel tables look at the resistance step between consecutive samples and fail after 15 of 30 samples; the 3.0 L LZO evaluates the raw temperature step only while the reading is between 140 and 1,070 °C and needs 12 bad samples out of 25. Both are Type B, so the MIL waits for a second faulty trip. Loose terminals, corroded pins and a harness weakened by heat are the usual triggers, though the sensor can also fail internally. CARB asks for such checks on all emission-related inputs. A steady but wrong reading falls under P242B.
Possible causes
- Loose or fretted terminal in the sensor connector high
- Harness insulation damaged by exhaust heat, intermittent contact medium
- Sensor element breaking up internally low
Symptoms
- MIL after the second faulty trip
- Sensor 3 value jumps in the scan tool live data
- Code comes and goes, often after rough roads or washing
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P242E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.