OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P242C

Exhaust Gas Temperature Sensor Circuit Low (Bank 1 Sensor 3)

P242C means the signal of exhaust temperature sensor 3 on bank 1 sits below its valid range. What that says about the wiring depends on the sensor type. GM's 2020 diesel tables (20OBDG04) read a resistance under 158 Ω as a grounded circuit and need 10 bad samples in a window of 20 (Type B); on the 3.0 L LZO a digital thermocouple module reporting below -72.8 °C counts the same way, with 19 of 25 samples. Ford's 2023 diesels use a voltage floor of 0.10 V, VW's 2014 Touareg TDI 0.68 V. Deutz describes P242C-00 as a grounded signal on the probe behind the SCR catalyst. A harness chafed through near the hot exhaust or a crushed connector is the usual find. The ECM then works with a substitute value and normally holds back regeneration.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 2C

Possible causes

  • Signal wire chafed and shorted to ground near the exhaust high
  • Connector damaged, wet or with pushed-back terminals medium
  • Sensor shorted internally medium

Symptoms

  • MIL on after the second faulty trip on GM
  • Sensor 3 shows an implausibly low temperature in the scan tool
  • Regeneration blocked, filter load rising

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P242C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication