P242B
Exhaust Gas Temperature Sensor Circuit Range/Performance (Bank 1 Sensor 3)
P242B flags a reading from exhaust temperature sensor 3 on bank 1 that is electrically fine but makes no physical sense. Most checks start from a cold soak: GM's 3.0 L LZO (25OBDG04B) waits for more than 10,800 s engine-off and then expects the probe to warm up enough, which exposes a probe that has slipped from the gas stream or is frozen at one value (Type B). Ford's 2023 diesels want every probe within 50 °C of the others after 6 h off; VW's 2014 Touareg TDI compares sensor 3 with four other temperatures (60 K) and with its model (100 K). Not every case is a part fault: Volvo and Mack traced P242B on 2015–2016 trucks to a miscalculated soak time and issued software, and Jaguar found the DPF probe of the AJ20-D4 diesel loose or out of place. Jumpy signals go to P242E.
Possible causes
- Sensor loose or no longer reaching into the exhaust stream high
- Sensor drifted or stuck at one value medium
- ECM software miscalculating soak time (Volvo/Mack 2015–2016, software update) medium
- Sensors swapped or wrong part fitted after repair low
Symptoms
- MIL on, often together with P2080 or P2084
- No DEF dosing or parked regeneration refused
- DPF warning lamp on
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P242B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.