P242A
Exhaust Gas Temperature Sensor Circuit (Bank 1 Sensor 3)
P242A is the general circuit code for the third exhaust temperature probe on bank 1. Where that probe sits is up to each manufacturer: VW counts it behind the oxidation catalyst on the 2014 Touareg TDI, Deutz places it downstream of the SCR catalyst on its EMR L1 controller. VW sets P242A once the signal voltage climbs above 2.61 V, which fits an open circuit. Deutz splits the code by failure type, -13 for an open, -F0 for a ground fault and -1C for a supply out of range. Ford's 2023 diesels give the number a different job: a probe that strays more than 80 °C from its modelled value for 20 s within one trip. Dedicated low and high faults go to P242C and P242D. Without a trustworthy reading the ECM usually suspends regeneration or DEF dosing.
Possible causes
- Open circuit or corroded terminal in the sensor connector or harness near the exhaust high
- Exhaust temperature sensor 3 failed internally medium
- Ground fault or sensor supply out of range (failure types -F0/-1C on Deutz) medium
- On Ford diesels, sensor reading deviating from the exhaust temperature model low
Symptoms
- MIL on
- Particulate filter regeneration or DEF dosing suspended
- Implausible or missing value for sensor 3 in the scan tool
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P242A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.