P2426
EGR Cooling Valve Control Circuit Low
P2426 is set when the command wire of the cooling valve reads too low, which on most driver stages means the wire is shorted to ground or the output cannot pull up. In Ford's Power Stroke summary the low and high faults are detected together by a short-circuit check of the cooler bypass actuator that runs all the time and fails after 2 seconds. Volkswagen instead applies a fixed limit to the CNRB 3.0 TDI of the 2014 Touareg: below 2.97 V on the signal the code is stored. Chafed insulation against the exhaust or the engine block is the usual cause. The bypass flap then stays in its default position, which can make the warm-up longer or the EGR gas hotter.
Possible causes
- Control wire chafed through and shorted to ground high
- Internal short in the valve actuator medium
- Faulty output stage in the engine control module low
Symptoms
- Check engine light
- Bypass flap no longer moves
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2426
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.