OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P241A

O2 Sensor Signals Swapped (Bank 1 Sensor 1 / Bank 1 Sensor 2)

With P241A the engine controller has concluded that the oxygen readings of the sensor ahead of the bank 1 catalyst and of the sensor behind it fit the opposite mounting positions, so the two plugs or harness legs are most likely crossed. FCA uses the code on the 2011 Ram 2500/3500 with the 6.7L Cummins diesel and calls it an oxygen concentration mismatch between sensors 1/1 and 1/2; bulletin 18-012-12 Rev. A brings revised ECM software for it among other faults. CARB requires every sensor used for fuel control and catalyst checks to be monitored. P241B is the bank 2 pair, P2416 the pair behind the catalyst. In practice the code follows a sensor or exhaust repair; mixture control and catalyst diagnosis then work with wrong data.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 1A

Possible causes

  • Upstream and downstream sensor plugs connected the wrong way round after a repair high
  • Sensor harness rerouted or wrong replacement harness fitted medium
  • Detection software needing an update (FCA 6.7L Cummins) low

Symptoms

  • Check engine light after work on the exhaust or the oxygen sensors
  • Mixture adaptation drifts, fuel trims look implausible
  • Catalyst or sensor codes set as follow-up faults

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P241A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication