OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P240E

Alternative Fuel High Pressure System Leak

P240E concerns the high-pressure side of a gaseous alternative-fuel system, from the storage cylinder through the tank valve and high-pressure line and filter up to the regulator. Pressures there are far higher than in the rail: CNG is stored at about 200-250 bar, and GM's PI1330 rates the 2015 Impala bi-fuel tank at 3,600 psi, with a high-pressure cut-off solenoid at the tank and a coalescing filter that is drained every 15,000 miles. LPG systems run at up to about 300 psi according to GM. No manufacturer publicly documents how P240E is detected; a loss of tank pressure that is not explained by consumption is the likely trigger. CARB treats CNG and LPG engines as alternate-fueled. P240D covers the regulated low-pressure side. Treat any warning as urgent, since gas escapes quickly at these pressures.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 0E

Possible causes

  • Leaking high-pressure fitting or line between cylinder and regulator high
  • Leaking tank valve or high-pressure cut-off solenoid medium
  • Leaking fill receptacle or its check valve medium
  • Leak at the high-pressure inlet of the regulator low

Symptoms

  • Check engine light, vehicle switches to petrol or will not run on gas
  • Gas gauge falls while parked
  • Hissing noise or gas smell near the tank

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P240E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication