P240C
EVAP System Leak Detection Pump Heater Control Circuit High
P240C flags the heater circuit of the leak detection pump at the high end: VW's 2014 Golf and Touareg books set it when the heater current exceeds about 2.2-4 A, which points to a shorted element or a line touching battery voltage. Jaguar's JTB00436 for the XJ (X351) quotes both P240C-00 and P240C-85, the 85 suffix marking a signal above range, among faults from water or ice in the DMTL filter; Land Rover's SSM69118 lists P240C-85 and SSM71298 P240C-00, each leading to a DMTL pump swap when nothing else is found. Maserati names P240C on its DMTL engines too. P240A means no current flows at all, P240B a grounded line. Without heating, the leak test can suffer in cold and damp weather; the car itself drives normally.
Possible causes
- Shorted heating element in the pump module, often after water ingress high
- Heater control wire shorted to battery voltage medium
- Faulty heater output stage in the engine control module low
Symptoms
- Check engine light
- Other DMTL codes after frost or heavy rain
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P240C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.