P240A
EVAP System Leak Detection Pump Heater Control Circuit/Open
Some leak detection pump modules, such as the DMTL units on VW, Jaguar Land Rover and Maserati petrol engines, carry a small heating element that keeps moisture and ice from upsetting the pump and its pressure measurement. P240A is set when the heater's drive circuit appears open. The 2014 data books for the VW Golf and Touareg take a heater-line voltage of about 4.7-5.4 V as the criterion. Jaguar's JTB00436 for the XJ lists P240A next to other DMTL codes that water or ice in the pump filter can cause, and Land Rover's SSM69118 and SSM71298 cover it as well. P240B and P240C are the short-circuit siblings; P2400 concerns the pump drive itself. Without heating the leak test may become unreliable in cold, damp weather.
Possible causes
- Burnt-out heating element inside the pump module high
- Broken heater wire or corroded terminal at the module connector medium
- Missing supply voltage to the heater (fuse, relay) low
Symptoms
- Check engine light
- Further EVAP pump codes in cold or wet conditions
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P240A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.