P2408
Fuel Cap Sensor/Switch Circuit
P2408 is the general circuit code for a sensor or switch that tells the engine computer whether the fuel cap or filler is closed. It is set when that circuit shows a fault not narrowed down to low, high, plausibility or dropout, which are P2410, P2411, P2409 and P2412. No manufacturer publicly documents this code; most systems infer the cap state from pressure instead. Ford's OBD summary, for example, detects a missing or loose cap (P0457) when the tank does not pull down past -8 inH2O within 30 s after refuelling, lights a Check Fuel Cap lamp and shows a capless-filler message. CARB lets makers skip the MIL for a detected cap leak if a separate warning lamp exists. The vehicle drives normally; the cap and wiring should be checked.
Possible causes
- Faulty fuel cap or filler switch high
- Damaged wiring or connector at the filler neck medium
- Aftermarket cap that does not actuate the switch correctly low
Symptoms
- Check engine light or fuel cap warning
- EVAP leak test may be skipped
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2408
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.