OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2405

EVAP System Leak Detection Pump Sense Circuit Low

P2405 is set when the feedback signal of the leak detection pump stays below its permitted window, typically from a short to ground on the sense line or a fault inside the pump. No public source states a voltage threshold for this code. It appears in Maserati's sheet MAS002203 (2020) for DMTL-equipped M156/M157/M161 petrol models from MY17, which notes that most DMTL checks run with the key off; Land Rover's SSM69118 and SSM71298 treat a confirmed P2405 as a defect within the DMTL pump, and the 2021 bulletin JLRTB02068NAS1 blames dirt entering through the pump's dust filter and replaces pump and filter cover. P2406 is the high-side counterpart, P2403 a missing signal. The car drives normally, but the EVAP test result is lost.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 05

Possible causes

  • Internal DMTL pump fault, often after dirt ingress through the dust filter high
  • Sense wire shorted to ground medium
  • Corroded connector at the pump mounted near the rear wheel arch low

Symptoms

  • Check engine light, possibly set while the car is parked
  • No effect on drivability

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2405

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication