P2403
EVAP System Leak Detection Pump Sense Circuit/Open
The sense circuit carries the feedback by which the engine computer knows what the leak detection pump is actually doing. P2403 is logged when that feedback is missing as if the line were open. The January 2014 Golf book from VW sets it once the sense signal stays at a low voltage for more than 0.5 s. Jaguar's bulletin JTB00436 for the XJ (X351, 2010 onwards) lists P2403 among the DMTL codes caused by road spray freezing or collecting in the pump filter, and Ford's code list for the 2014 Boss 302S carries the same title. Compared with P2400 the pump may run normally; only its feedback is lost. P2405/P2406 are the low/high siblings, P2404 the plausibility check. The tank leak test cannot be evaluated; drivability is not affected.
Possible causes
- Broken feedback wire or backed-out terminal at the pump connector high
- Water or ice trapped in the pump or its filter (Jaguar XJ) medium
- Failed feedback element inside the pump medium
Symptoms
- Check engine light
- EVAP monitor not completed
- More often after winter driving or car washes
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2403
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.