OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2402

EVAP System Leak Detection Pump Control Circuit High

P2402 points to the opposite fault of P2401: the pump control line sits at supply voltage or the pump draws too much current. GM's Volt tables call it a short to power detected while the driver is on; when it is active the ECM runs an intrusive check, running the pump for 15 s on command, with a Type B code after 20 failed samples out of 25. In VW's Golf data book of 2014 the limit is a pump current above 3.0 A or, on other engines, the voltage across the pump's current-measuring resistor (about 1.8-4.0 V). Acura recalled 2021-22 TLX Type S models (B22-007) because faulty PGM-FI software could keep the MIL on and P2402 stored after an ELCM circuit repair; Audi and Land Rover also publish P2402 cases. Driving is unaffected, but the evaporative leak check is skipped.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 02

Possible causes

  • Leak detection pump motor seized or drawing excessive current high
  • Control wire shorted to a battery-voltage feed medium
  • Control module software that does not clear the fault after repair (Acura TLX Type S recall) low

Symptoms

  • Check engine light that may persist after repair until software is updated
  • EVAP readiness incomplete, inspection may fail

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2402

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication