OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2400

EVAP System Leak Detection Pump Control Circuit/Open

P2400 is stored when the engine computer finds the drive line of the evaporative leak detection pump open, so the pump cannot be switched for the tank leak test. GM's tables for the sealed fuel system of the Volt (2011, 2016) compare the commanded and actual driver state and treat a low voltage in the off state, equal to more than 200 kOhm to ground, as an open; 20 failed samples out of 25 at 250 ms each set a Type B code. VW's 2014 Golf data book flags a signal voltage of roughly 4.4-5.6 V. Toyota names P2400 with failure types 7E/7F on A25A engines, and VW traced P2400 on the 2011-2014 Touareg 3.6 to coolant entering the pump's vacuum line. P2401 and P2402 are the short-circuit siblings. The leak test cannot run; the car drives normally.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number4 / 00

Possible causes

  • Corroded or loose pump connector, broken wire in the drive line high
  • Open winding or internal fault in the leak detection pump medium
  • Coolant in the pump's vacuum supply line from a failed coolant pump changeover valve (VW Touareg 3.6) low
  • Faulty output stage in the engine control module low

Symptoms

  • Check engine light
  • EVAP readiness monitor stays incomplete
  • No noticeable change in driving behaviour

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2400

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication