OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23F9

Cylinder 8 Injector B Air-Fuel Ratio Imbalance

P23F9 points to cylinder 8, the highest number on any V8. GM's 2019 tables for the LT5 Corvette show how far a V8 with port and direct injection resolves imbalance in practice: only bank by bank. For bank 2 the monitor samples the front oxygen sensor once per cylinder event, normalises the variance against a map and fails when the filtered ratio exceeds 0.75, a Type A fault that turns on the MIL after one trip. A cylinder code that also names the injector therefore needs more than the bank-level method can deliver, and no manufacturer has published that it uses P23F9. Ford's Coyote 5.0 since 2018 and Toyota's 2UR-GSE are further V8s with dual injectors. Which bank cylinder 8 sits on follows the maker's numbering; P21A3, P0308 and P21D6 help.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / F9

Possible causes

  • Injector B of cylinder 8 with wrong flow rate high
  • Leak at the intake runner or PCV connection near cylinder 8 medium
  • Front oxygen sensor of the bank giving a distorted signal low

Symptoms

  • Check engine light on
  • Bank-level imbalance code (P219A/P219B) stored as well
  • Normal drivability in most cases

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P23F9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication