OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23F4

Cylinder 3 Injector B Air-Fuel Ratio Imbalance

P23F4 refers to cylinder 3: the control unit has found that this cylinder burns leaner or richer than the others and traces the deviation to injector B. On a three-cylinder engine with port and direct injection, such as the Ford 1.5 EcoBoost, cylinder 3 is the last one; on four- and six-cylinder engines it lies in the middle of the block or bank. CARB lets a manufacturer store a misfire code instead of an imbalance code if exact identification would need extra hardware and misfire detection catches the fault reliably. A P0303 can therefore stand for the same cause. No maker documents P23F4 publicly. Port injectors that drip or clog and a leaking seal at the intake port of cylinder 3 should be checked first; P219E is the matching code without the injector letter.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / F4

Possible causes

  • Port injector (injector B) of cylinder 3 dripping or partly blocked high
  • Leaking seal at the intake port of cylinder 3 medium
  • Low compression or leaking valves on cylinder 3 low

Symptoms

  • Check engine light on
  • Possible misfire code P0303 at the same time
  • Uneven idle when the engine is warm

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23F4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication