OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P23F3

Cylinder 2 Injector B Air-Fuel Ratio Imbalance

P23F3 points to cylinder 2 and to its injector B, the second of two injectors feeding that cylinder. The smallest engines able to raise it have three cylinders, for example Ford's 1.5 EcoBoost, which pairs port and direct injection and can switch one cylinder off at light load. On V engines the bank that holds cylinder 2 depends on how the maker numbers its cylinders, so read the service information before working on a side. Hyundai's Smartstream 1.0 and 1.2 MPi engines show that both injectors of a cylinder may also sit in the intake port; whether such a design calls one of them B is not published. No public document ties P23F3 to a vehicle. Compare with P219D for the same cylinder and with P21D0 for the injector B circuit.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number3 / F3

Possible causes

  • Injector B of cylinder 2 delivering too much or too little fuel high
  • Air leak at the intake port or injector seal of cylinder 2 medium
  • Work done on the wrong cylinder because of the maker's numbering scheme medium
  • Chafed wire to injector B of cylinder 2 (check P21D0) low

Symptoms

  • Check engine light on
  • Shaking at idle, most noticeable on small three- or four-cylinder engines
  • Slightly higher fuel consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P23F3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication