P23F1
Camshaft B Position Signal Output Circuit High (Bank 2)
P23F1 means the camshaft B output for bank 2 sits at a high level that the ECM did not command. Its driver switches the line to ground to form the pulses; if the line stays high while switched, current is coming in from elsewhere – typically a short to a supply wire in a shared harness bundle, sometimes water bridging terminals. The GM bank 1 camshaft A analogue P2616 judges this at 0.5 ohm or less to power, with at least 11 V at the powertrain relay, and classes it as Type C. There is no published manufacturer description of P23F1. Measure the line with the receiver unplugged: if the voltage disappears, the receiving module is the source. Counterparts are P23EE for bank 1 and P23F0 for a line stuck low.
Possible causes
- Short to a supply wire within a shared harness bundle high
- Water bridging connector terminals medium
- Receiving module feeding voltage back into the line low
- ECM driver no longer switching low
Symptoms
- Code present, no change in engine behaviour
- Communication or plausibility faults in the receiving module
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P23F1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.