P23EF
Camshaft B Position Signal Output Circuit/Open (Bank 2)
P23EF covers the last combination of this series: camshaft B, usually the exhaust shaft, on bank 2, the cylinder bank without cylinder 1. On V-engines with four camshafts the ECM can provide a separate phase output per shaft, and P23EF says the bank 2 exhaust output has lost circuit continuity – a broken wire, a terminal backed out of its connector or a missing load at the receiving end. No manufacturer documents P23EF publicly. GM evaluates its comparable camshaft A outputs only with the engine not cranking and the powertrain relay at 11 V or more, and those faults do not turn on the MIL. Shorts are separated out as P23F0 (to ground) and P23F1 (to power); bank 1 has the same open-circuit check under P23EC.
Possible causes
- Wire break in the bank 2 camshaft B output line high
- Terminal backed out of the connector housing medium
- Receiving module disconnected or with failed input low
Symptoms
- Code stored without warning lamp on many vehicles
- Module relying on the signal sets its own fault codes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P23EF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.